The ControllinoTrainingsboard is suitable in Controllino and/or Arduino education and training for learning, testing, and simulation. An Arduino Sketch is therefore transferred to the Controllino. On the Controllino-Trainingsboard every function of the program can be simulated and tested in detail with different sensors and actuators.
Ideal for IHK exam preparation or for "learning by doing"
The didactic exercises with training cards / learning cards included in the scope of delivery support you from the creation of a program up to testing and checking the functions. The available sensors can be switched on or off as required on the
Controllino-Trainingsboard. Thus up to 8 push/latch switches, 4 analog value transmitters (0-10Volt) and/or one pulse transmitter (2-1000 Hz, linear) are available. The actuators are 8 LEDs and a buzzer.
An overview of all Controllino-Trainingsboard Sets can be found
here!
Technical data:
Sensors/Input
8 push button / latching switch for simulation of input signals
(to be used as switches or buttons, simulating break contact or closing contact)
6 analog inputs for simulation of analog sensors with 0-10 volt
(The analog inputs can be alternatively connected via 6 switches to analog inputs)
1 pulse generator to simulate the fast counter inputs
(The pulse generator can be connected via a switch to an Interrupt input)
Actuators/Outputs
8 LEDs indicating status of the outputs
1 signal transmitter
The signal transmitter can be switched on alternatively to an output
Additionally
1 placeholder for Trainingcards
The training cards illustrate the task and the use of sensors and actuators.
1 power supply
The Controllino-Trainingboard has to be operated with 24 V DC.
1 LED for voltage monitoring
the LED indicates a sufficient power supply in the range of 12... 24 volt
1 interface connector 40 pin
for connecting "Interface modules", for example Traffic Light or "Interface Module 1"
The Controllino-Trainingboard is mounted on an aluminum bracket.
Note
The Controllino-Trainingsboard is suitable for the following PLC / SPS:
- Controllino MAXI and
- Controllino MAXI Automation
Scope of delivery
Controllino-Trainingboard mounted on aluminium bracket
size with aluminium bracket and Controllino: (L x W x H) approx. 250 x 170 x 110 mm
Set of cables for wiring the Controllino
Note: The Controllino is not included in the delivery!
Plug power supply
universal input 90-264 VAC, output 24V/1A, 24 Watt, high efficiency and low StandBy consumption, overload and short-circuit protected
USB stick contains
technical manual as PDF
didactic task descriptions as PDF
Sample solutions as a Sketch, approximately 32 pieces
(Partially a Trainings Card contains multiple tasks or there are several solutions for a task)
30 training cards
suitable for task descriptions, tasks divided into 3 levels of difficulty
Attention
The "
Controllino-Trainingsboard - Starter Kit" comes without Controllino.
Suitable for:
- Controllino MAXI Automation (recommended)
- Controllino MAXI
