The "Logo8-Extension Module for AM2 AQ" can be connected to the "Logo8-Trainingsboard" and provides 2 additional analog outputs. The two analog outputs (0-10 volts) of the first AM2 AQ module are available on the "Logo8-Trainingboard" on the 40-pin "Interface" connector. From there, they can be used with the "Interface Module 1" in external models.
Technical data:
Sensors/input
no
Actuators/outputs
2 analog outputs 0-10 volt
(the inputs of the first "Logo8-Extension Module for AM2 AQ" are present on the 40-pin interface on the "Logo8-Trainingsbaord")
More
Power supply via the "Logo8-Trainingboard"
The "Logo8-Extension Module for AM2 AQ" is mounted on an aluminum bracket.
Note
The "Logo8-Extension Module for AM2 AQ" is suitable for the following Logo! Analog Module:
Logo! AM2 AQ (manufacturer part number: 6ED1055-1MM00-0BA2).
To operate the "Logo8 Extension Module for AM2 AQ", the "Logo8-Trainingboard" must be supplied with a voltage of 24 V DC. The plug-in power supply unit with the order number L-7012 is suitable for this purpose.
Scope of delivery
"Logo8-Extension Module for AM2 AQ" mounted on aluminum bracket
size with aluminium bracket and Logo! AM2 AQ Module (L x W x H) approx. 35.5 x 170 x 110 mm
Connection material
(for the connection of the aluminium brackets of "Logo8-Trainingboard" and "Logo8-Extension Module)
Set of cables for wiring the Logo! AM2 AQ module
Note
The Logo8 AM2 AQ module is not included in the delivery!
