The S7-1200-Trainingsboard is suitable for Siemens S7-1200 and/or TIA Portal education and training for learning, testing, and simulation. A Program can therefore be transferred to the S7-1200. On the S7-1200-Trainingsboard every function of the program can be simulated and tested in detail with different sensors and actuators.
Ideal for exam preparation or for "learning by doing"
The didactic exercises with training cards / learning cards included in the scope of delivery support you from the creation of a program up to testing and checking the functions. The available sensors can be switched on or off as required on the
S7-1200-Trainingsboard. Thus up to 8 push/latch switches, 2 analog value transmitters (0-10Volt) and/or one pulse transmitter (2-1000 Hz, linear) are available. The actuators are 8 LEDs and a buzzer.
An overview of all S7-1200-Trainingsboard Sets can be found
here!
Technical data:
Sensors/Input
8 push button / latching switch for simulation of input signals
(to be used as switches or buttons, simulating break contact or closing contact)
2 analog inputs for simulation of analog sensors with 0-10 volt
1 pulse generator to simulate the fast counter inputs
(The pulse generator can be connected via a switch to a counter input)
Actuators/Outputs
8 LEDs indicating the status of the outputs
1 signal transmitter
The signal transmitter can be switched on alternatively to an output
Additionally
1 placeholder for Trainingcards
The training cards illustrate the task and the use of sensors and actuators.
1 power supply
The S7-1200-Trainingboard has to be operated with 24 V DC.
1 LED for voltage monitoring
the LED indicates a sufficient power supply in the range of 12... 24 volt
1 interface connector 40 pin
for connecting "Interface modules", for example, Traffic Light or "Interface Module 1"
The S7-1200-Trainingboard is mounted on an aluminum bracket.
Note
The S7-1200-Trainingsboard is suitable for the following PLC / SPS:
- Siemens S7-1200
- recommended Siemens CPU 1215C - 6ES7215-1AG40-0XB0, to use all features
Scope of delivery
S7-1200-Trainingboard mounted on aluminium bracket
size with aluminium bracket and S7-1200: (L x W x H) approx. 325 x 170 x 125 mm
Set of cables for wiring the S7-1200
Note: The S7-1200 is not included in the delivery!
Plug power supply
universal input 90-264 VAC, output 24V/1A, 24 Watt, high efficiency and low StandBy consumption, overload and short-circuit protected
USB stick contains
technical manual as PDF
didactic task descriptions as PDF
Sample solutions as a Sketch, approximately 32 pieces
(Partially a Trainings Card contains multiple tasks or there are several solutions for a task)
30 training cards
suitable for task descriptions, tasks divided into 3 levels of difficulty
Attention
The "
S7-1200-Trainingsboard - Starter Kit" comes without PLC.
Suitable for:
- Siemens S7-1200
- recommended Siemens CPU 1215C DC/DC/DC - 6ES7215-1AG40-0XB0, to use all features
- TIA Portal
