The RevPI-Trainingsboard is suitable in Kunbus RevPI (Respberry PI) and/or CODESYS education and training for learning, testing, and simulation. A CODESYS Program can therefore be transferred to the RevPI. On the RevPI-Trainingsboard every function of the program can be simulated and tested in detail with different sensors and actuators.
Ideal for exam preparation or for "learning by doing"
The didactic exercises with training cards / learning cards included in the scope of delivery support you from the creation of a program up to testing and checking the functions. The available sensors can be switched on or off as required on the
RevPI-Trainingsboard. Thus up to 8 push/latch switches and 2 analog value transmitters (0-10Volt) are available. The actuators are 8 LEDs and a buzzer.
See also:
„RevPI-Trainingsboard - SET 1“
Technical data:
Sensors/Input
8 push button/latching switch for simulation of input signals
(to be used as switches or buttons, simulating break contact or closing contact)
2 analog inputs for simulation of analog sensors with 0-10 volt
Actuators/Outputs
8 LEDs indicating the status of the outputs
1 Buzzer
The signal transmitter can be switched on alternatively to an output
Additionally
1 placeholder for Trainingcards
The training cards illustrate the task and the use of sensors and actuators.
1 power supply
The RevPI-Trainingboard has to be operated with 24 V DC.
1 LED for voltage monitoring
the LED indicates a sufficient power supply in the range of 12... 24 volt
1 interface connector 40 pin
for connecting "Interface Modules", for example, Traffic Light or "Interface Module 1"
The RevPI-Trainingboard is mounted on an aluminum bracket.
Note
The RevPI-Trainingsboard is suitable for the following Kunbus Modules:
Scope of delivery
RevPI-Trainingboard mounted on aluminium bracket
size with aluminium bracket and RevPI: (L x W x H) approx. 325 x 170 x 150 mm
Set of cables for wiring the RevPI Modules
Note: The RevPI Modules are not included in the delivery!
Plug power supply
universal input 90-264 VAC, output 24V/1A, 24 Watt, high efficiency and low StandBy consumption, overload and short-circuit protected
USB stick contains
technical manual as PDF
didactic task descriptions as PDF
Sample solutions for CODESYS as FUP, COP, ST
(Partially a Trainings Card contains multiple tasks or there are several solutions for a task)
30 training cards
suitable for task descriptions, tasks divided into 3 levels of difficulty
Attention
The "
RevPI-Trainingsboard" - Starter Kit" comes without PLC.
Suitable for:
- KUNBUS Revolution Pi -REVPI Connect -REVPI DIO -REVPI AIO
- CODESYS (free version could be sufficient)
